and what is the use of the 22k and 10k..blue line...cant find it in the manual
oh i forgot...and what is the use of the capacitor in the right side of the l293d...
in the picture...the blue wire connected to the holes....what is the used of that holes?
the documentation says
blue wire ECHO output
yellow wire TRIGGER input
btw this works...just dont know how it went that way
i have this problem a while ago wherein i cant program the picaxe 28x1..
when i plug in the battery(4.3v) the servo jerks alittle bit so that was an indication that the battery is workin...
but i cant program it...
i tried to put 5volts the servo doesnt jerk and still i cant program...
arent there anymore updates in this section?
http://www.rev-ed.co.uk/docs/axe001_pcb.pdf
the only one in there is picaxe28
i just want to know the details of my picaxe28x1...
EDIT i think this is it but i cant access it...it says picaxe28x1 module...http://www.rev-ed.co.uk/docs/axe200.pdf...
So is this correct? i would just remove the jumpers? connect the v1 to the battery clip(the 9volt thingy)? and solder v2?
v1 would be 4.5V
v2 would be 5V
Thank You Again...
is this connection right?
if the switch is pressed it is high right?
i cant understand the manual...
im using picaxe 28x1 starter pack...
thank you in advance