Craftybytes
Senior Member
What i/o pins on the 28X1 chip support 'interrupts'..?
Looked at the Manual - could not find where this is referenced..!
Also - if I run the 28X1 using a 16Mhz crystal - what would be the MIPS throughput..?
In my project I need at least 5 x inputs with 3 supporting 'interrupt on falling edge' conditions..
Any help appreciated..
crafty.
.
Looked at the Manual - could not find where this is referenced..!
Also - if I run the 28X1 using a 16Mhz crystal - what would be the MIPS throughput..?
In my project I need at least 5 x inputs with 3 supporting 'interrupt on falling edge' conditions..
Any help appreciated..
crafty.
.