Recent content by Brian M

I have been trying to log in to the "Shop", but as I hadn't been on since some changes were made, I followed the route of forgotten password as advised on the site. I the past 36 hours I have sent the emailed requests but have not had any response. Anyone else having difficulties ? I was going...

Probably me be thick, but I have looked everywhere on the site for an answer to this and can't find it. On the simulation panel, when running a program the pins shown on the device can be either clear, light grey, dark grey, yellow or green. What exactly does each colour signify for the pin...

Editor 6 Panels Question When running a simulation in Editor, If I hide the panels, how do I unhide them ? Possible or not ?

I would like to try the Dorji 886 TX/RX modules on a remote monitoring project I have in mind, but trying to find a supplier in or close to the UK is proving to be a bit of a problem. I don't know if I am missing something, but just can't seem to find anything using the usual search engines...

I'm looking to build myself a prototyping station incorporating my AXE091 development board, but with integral and hidden/accessible 12V and 5V regulated supplies built into the station. In addition, a facility to plug in LCD display boards (2xaa, 4xaa). Enough space to mount motors, servos...

Asked this question via PicAXE.com support yesterday, but as yet, no reply. The BAT004HSM battery clip is advertised to enable battery back up for the RTC when used on the AXE091 development board. There is however, no information (easily available) that I can find to show how this is best...

Need an expert to look at this piece of code (not my original, just bits cobbled together) and can you spot my mistake. The timed switching works fine but the serial output to the LCD display doesn't at initial switch on. If I disconnect the power supply lines to the display and re-connect...

Pardonner mon Français mais j'ai une question. J'ai une maison secondaire dans departement 23. Fait n'importe qui connaître d'un magasin qui vend des composants électroniques dans le Limoges/Geuret environs où je pourrais acheter des composants pour mon PicAxe projets. Merci