Hi all, this is my first post, so please be gentle...
I am a newbie with PICAXE, and am trying to get a Sunlike SC1602C LCD module going with a PICAXE 20M processor. (with no luck yet ) I am trying to get it going in parallel 4 bit mode.
I have followed the wiring setups from revolution and hippy, and much of there code but still no luck.
I noticed that this LCD has PIN6 (Enable) as Level High with High to Low for triggering. Is this normal ? as it looks from most code samples I have seen that Enable is usually left LOW then pulsed to HIGH.
anyway I have tried both setups, with no luck....
I was thinking of geting a serial chip to se if I could get it to work !!
Or maybe another type of LCD display...
any Ideas for this DISPLAY
thanks in advance
BIGBAD
I am a newbie with PICAXE, and am trying to get a Sunlike SC1602C LCD module going with a PICAXE 20M processor. (with no luck yet ) I am trying to get it going in parallel 4 bit mode.
I have followed the wiring setups from revolution and hippy, and much of there code but still no luck.
I noticed that this LCD has PIN6 (Enable) as Level High with High to Low for triggering. Is this normal ? as it looks from most code samples I have seen that Enable is usually left LOW then pulsed to HIGH.
anyway I have tried both setups, with no luck....
I was thinking of geting a serial chip to se if I could get it to work !!
Or maybe another type of LCD display...
any Ideas for this DISPLAY
thanks in advance
BIGBAD
Attachments
-
167.5 KB Views: 24