M motherhugger New Member Sep 24, 2009 #1 is this connection right? if the switch is pressed it is high right? i cant understand the manual... im using picaxe 28x1 starter pack... thank you in advance
is this connection right? if the switch is pressed it is high right? i cant understand the manual... im using picaxe 28x1 starter pack... thank you in advance
M motherhugger New Member Sep 24, 2009 #3 so the connection is correct? no need for resistor? in all 3-pin snap switch..the right most is the +V and the middle is GND? so this code: main: if pin 2 = 1 then light goto main light: high 0 goto main if the switch is pressed LED on out 0 lights up.... hope im correct coz im gonna test it later... im just afraid i would fry the thing... thank you for your help...
so the connection is correct? no need for resistor? in all 3-pin snap switch..the right most is the +V and the middle is GND? so this code: main: if pin 2 = 1 then light goto main light: high 0 goto main if the switch is pressed LED on out 0 lights up.... hope im correct coz im gonna test it later... im just afraid i would fry the thing... thank you for your help...
A Andrew Cowan Senior Member Sep 24, 2009 #4 The resistors are all in the little (black) strip to the right of the green box. A