Gramps
Senior Member
Watch "March 19, 2020" on YouTube
The problem is connecting the servo to square stock.
This is one way to do it.
Watch "March 19, 2020" on YouTube
We need 120 degrees variation but can only get 90 with this configuration.
We could use a shaft directly connected to the servo hub and a belt drive, however would rather have a linkage connection if possible.
Been scratching my head all afternoon. Perhaps someone has that brilliant simple solution!
Thanks, Gramps
The problem is connecting the servo to square stock.
This is one way to do it.
Watch "March 19, 2020" on YouTube
We need 120 degrees variation but can only get 90 with this configuration.
We could use a shaft directly connected to the servo hub and a belt drive, however would rather have a linkage connection if possible.
Been scratching my head all afternoon. Perhaps someone has that brilliant simple solution!
Thanks, Gramps