I have built the above board and programmed the Picaxe for the first project where 3 LED's light up in succession.(this is the first project one does as a beginner)
It works however the third LED (green)does not light up.The board accepted the program and OK'd it.It runs but no green light.
The LED is the right way about,all soldering has been re-checked,all switches are on.The program is a copy of what is in the literature.A multimeter check on the other LED's shows a pulse of voltage arriving at approx the time when the LED lights up but no pulse arrives on the green.Can anyone help?
Peterb62(a beginner)
It works however the third LED (green)does not light up.The board accepted the program and OK'd it.It runs but no green light.
The LED is the right way about,all soldering has been re-checked,all switches are on.The program is a copy of what is in the literature.A multimeter check on the other LED's shows a pulse of voltage arriving at approx the time when the LED lights up but no pulse arrives on the green.Can anyone help?
Peterb62(a beginner)