Schematic for Axe033 LCD board

R

rmeldo

Senior Member
Hy everyone and technical.

I am wiring up a Axe033 kit and the board has several holes for additional connectors, resistor, etc, beyond what is supplied witht he kit.

Some of them are explained in the datasheet.

I want to create a setup for prototyping things I haven't tohught of yet, so I need something general and I could reaaly do with the schematics of the board.


What I am talking about is the equivalent of the diagram at page 6 of datasheet for the the AXE110P datalogger.

Does anyone know if something like that exists?

Thanks in advance

Riccardo
 
W

westaust55

Moderator
Believe Rev Ed has not released a schematic.

Maybe post a photo with some added marks (use for example MS Paint) to indicate exactly which holes you are talking about. Then someone here maybe able to hlep in some way.
 
R

rmeldo

Senior Member
Thanks westaust55 (I don't know how long i need to belong to the forum for before I can start calling you Westy).

Good suggestion, I will do it tonight once the kid has gone to bed.

Riccardo
 
A

alband

Senior Member
I vaguely remember them giving a small set of instructions which tells you how to wire up. I also recall there being some jumpers to solder.
 
R

rmeldo

Senior Member
Thans all for the advice.

A case of RFM!

Also no point in having the schematics, as the 20 pin chip fitted is firmware.

I think I understand how to wire it up now. I am still going to attach the LCD to the board with a connector, rather than solder then together.

I might want to separate them in the future.

Riccardo
 
You must log in or register to reply here.
Top