pwmout & servo commands

[AlbertZ]

It is my understanding that the 18M2 chip has two separate timers which allows using pwmout as well as the servo commands. My question is this: If I am generating a PWM output signal on Port B.6, can I use any PortC pin to issue a servo command or must I use Port B.3?

 

[hippy]

You do not have to use a PWM output channels to control a servo; any Port B pin can be used.

Note that servos controlled by SERVO commands can only be on Port B, not Port C.

 

[AlbertZ]

Thanks Hippy

That's what I needed to know