Rickharris
Senior Member
This is associated with my radio control thread but a different issue as this seems to be Picaxe based.
The pulsout command "Seems" to give an output I don't expect from my understanding of what it is supposed to do:
The following code:
should give a 1 milli second positive pulse spaced every 5 milli seconds
It appears on both of the PC scope progs I am using it gives a negative pulse.
On my logic probe the out put can be seen pulsing.
If I then change the code to:
I get nothin out at all even on the logic probe the output just goes high and stays there.
Has anyone else experience with the axe20? and pulsout. This seem quite odd.
The pulsout command "Seems" to give an output I don't expect from my understanding of what it is supposed to do:
The following code:
Code:
start:
pulsout 2,100
pause 5
goto start
It appears on both of the PC scope progs I am using it gives a negative pulse.
On my logic probe the out put can be seen pulsing.
If I then change the code to:
Code:
high 2
start:
pulsout 2,100
pause 5
goto start
Has anyone else experience with the axe20? and pulsout. This seem quite odd.