Hello, im a sixth form student. Currently making a final project. I am using the PICAXE 28X and the ULN2803 driver (http://194.201.138.187/epages/Store.storefront/?ObjectPath=/Shops/Store.TechSupplies/Products/ICO050) for my stepper motor (http://194.201.138.187/epages/Store.storefront/?ObjectPath=/Shops/Store.TechSupplies/Products/GBX008)
the basic programming is there but that is only if im using the picaxe chip not the ULN2803 chip aswel.
Could anybody help me out with programming the overall circuit board? I can use basic and logicator but i'm just a bit confused
Contact information
Either, reply to this thread, or message me please
Thanks
the basic programming is there but that is only if im using the picaxe chip not the ULN2803 chip aswel.
Could anybody help me out with programming the overall circuit board? I can use basic and logicator but i'm just a bit confused
Contact information
Either, reply to this thread, or message me please
Thanks
Last edited: