bulltalk.65
New Member
Hello all,
I'm new here although I've been skating around and reading for a time. I have the 18x board with the axeo27 cable and software loaded..
if I have posted this in the wrong place I apologise, maybe the moderator can place it correctly.
alittle about me first, I'm 43 and a high school education, have no (none) previous experience with electronics or microcontrollers other than what I have become interested in over the last 10 months. I am a member of another site and its theme is trailcameras and that is where my interest has come from.
there are a few who have decided to do this for our own purposes and I happen to be one of them.
my problem is, or maybe I should clarify something first. I am under the impression that you may use any picaxe chip with your program board as long as it is equivalent to or smaller than what I have, mine is the 18X but I want to load a program to a 08m on my 18x board. if I mis interpreted what I read, then I guess I better start over again.
the main problem is I can syntax check and even run a simulation on my editor but it won't let me load the program to the chip, I'll post a pic of the window that continues to pop up no matter what I change in my system (port wise) or whatever I try it always says the same thing. all updates have been installed including the drivers.
Any help with this would be very much appreciated, I'm a rookie so be easy on me, I just bought my first computer last christmas...
here's a pic;
George
I'm new here although I've been skating around and reading for a time. I have the 18x board with the axeo27 cable and software loaded..
if I have posted this in the wrong place I apologise, maybe the moderator can place it correctly.
alittle about me first, I'm 43 and a high school education, have no (none) previous experience with electronics or microcontrollers other than what I have become interested in over the last 10 months. I am a member of another site and its theme is trailcameras and that is where my interest has come from.
there are a few who have decided to do this for our own purposes and I happen to be one of them.
my problem is, or maybe I should clarify something first. I am under the impression that you may use any picaxe chip with your program board as long as it is equivalent to or smaller than what I have, mine is the 18X but I want to load a program to a 08m on my 18x board. if I mis interpreted what I read, then I guess I better start over again.
the main problem is I can syntax check and even run a simulation on my editor but it won't let me load the program to the chip, I'll post a pic of the window that continues to pop up no matter what I change in my system (port wise) or whatever I try it always says the same thing. all updates have been installed including the drivers.
Any help with this would be very much appreciated, I'm a rookie so be easy on me, I just bought my first computer last christmas...
here's a pic;
George
Attachments
-
154.9 KB Views: 23