This is somewhat related in that my printed circuit board design is for a Picaxe 28x1 circuit, however I honestly have not designed many circuit boards and am looking for constructive criticism. I've read some sources that indicate PCB traces should look one way, and others that contradict that advice...
So I was hoping to draw on your experience, if possible.
It is a circuit that turns two pumps on and off based on some level switches. One vessel has a high / low switch combination, and the other is used for top-up applications. My intention was to collect information and wirelessly transmit it back to a PC or another Picaxe circuit as well... for now I'm using a 315Mhz transmitter pair from Sparkfun, but hope to ultimately upgrade to the XBee protocol.
Any words of wisdom would be greatly appreciated...
So I was hoping to draw on your experience, if possible.
It is a circuit that turns two pumps on and off based on some level switches. One vessel has a high / low switch combination, and the other is used for top-up applications. My intention was to collect information and wirelessly transmit it back to a PC or another Picaxe circuit as well... for now I'm using a 315Mhz transmitter pair from Sparkfun, but hope to ultimately upgrade to the XBee protocol.
Any words of wisdom would be greatly appreciated...
Attachments
-
281.9 KB Views: 97