Hey guys I'm having major problems here, any advice would be really handy. I have 2 18 pin project boards and the 28 pin project board. I'm having universal problems across them all.
I tell either of the 18 pin boards to send pin 3 high (with code below). Its sends pin 3 high but only outputs 600mV not the fill 4.3 volts from the 3AA cell bat pack. Tried new bats and a power pack and still does the same (both the 18 pin boars and same on the 28 pin board now as well).
I have checked the volts out with a multimeter and a scope. its always the same 600mV-610mV. My end aim it to PWM on pin three, had it all working well earlier, checked it with the scope all was working well. But now I'm having this problem, any ideas ?
Thanks for the help,
Tom
main:
high 3
goto main
end
I tell either of the 18 pin boards to send pin 3 high (with code below). Its sends pin 3 high but only outputs 600mV not the fill 4.3 volts from the 3AA cell bat pack. Tried new bats and a power pack and still does the same (both the 18 pin boars and same on the 28 pin board now as well).
I have checked the volts out with a multimeter and a scope. its always the same 600mV-610mV. My end aim it to PWM on pin three, had it all working well earlier, checked it with the scope all was working well. But now I'm having this problem, any ideas ?
Thanks for the help,
Tom
main:
high 3
goto main
end