radovan.matej@hotmail.com
New Member
Hello.
I am using a 4x3 keypad to send data to picaxe 28x2. Data are then sent to LCD module. These data contain an information about the angle of motor. (0-180 degree)
I haven't figured out what kind of motor i should use. Stepper or servo motor ?
After i write an info on keyboard, for ex. 128, that means the motor should move to position 128(degree).
Script for keyboard and lcd module is already done, but i don't know where to move on from here.
Any suggestions? Thank you.
I am using a 4x3 keypad to send data to picaxe 28x2. Data are then sent to LCD module. These data contain an information about the angle of motor. (0-180 degree)
I haven't figured out what kind of motor i should use. Stepper or servo motor ?
After i write an info on keyboard, for ex. 128, that means the motor should move to position 128(degree).
Script for keyboard and lcd module is already done, but i don't know where to move on from here.
Any suggestions? Thank you.