Hi I have 433 module which I am trying to set setup . I have used the code below to program my picaxe . Now without the whole circuit connected just the picaxe powered up
the output led on output 4 flashes regardless of what input is doing. I have isloated the picaxe form main circuit still does the same . Tried different picaxes . have got 100nF cap from rail to Gnd . Not sure what to do
Thanks
(code)
input 1 '
pause 3000
main:
if pin1=0 then checkdata
goto main
checkdata:
b9 = 0
serout 2,T2400,(85,85,85,85,"sink",b9)'
for b0 = 1 to 4
high 4
pause 500
low 4
next b0
goto main
(code)
the output led on output 4 flashes regardless of what input is doing. I have isloated the picaxe form main circuit still does the same . Tried different picaxes . have got 100nF cap from rail to Gnd . Not sure what to do
Thanks
(code)
input 1 '
pause 3000
main:
if pin1=0 then checkdata
goto main
checkdata:
b9 = 0
serout 2,T2400,(85,85,85,85,"sink",b9)'
for b0 = 1 to 4
high 4
pause 500
low 4
next b0
goto main
(code)