thanks again for your support ..
I have been fighting this thing through the weekend.
I'm able to get the chip programed but the LED are not responding.
I use the code the datasheets describe and the wiring.
I want to use a switch and ligth the led.
Used the project board switch and leds but no luck also the breadboard and my own wiring and still no luck.
Ohhh i'm using the 28X1 chip
this is the code i used:
main: ‘ make a label called ‘main’
if pin3 = 1 then flash ‘ jump if the input is on
goto main ‘ else loop back around
flash: ‘ make a label called ‘flash’
high 4 ‘ switch output 4 on
pause 2000 ‘ wait 2 seconds
low 4 ‘ switch output 4 off
goto main ‘ jump back to start
Question: When the code specify pin3 does it mean input 3 or leg 3 ?
Is there something wrong with the code?
Once again thank for the support. Thank you !!!!!
I have been fighting this thing through the weekend.
I'm able to get the chip programed but the LED are not responding.
I use the code the datasheets describe and the wiring.
I want to use a switch and ligth the led.
Used the project board switch and leds but no luck also the breadboard and my own wiring and still no luck.
Ohhh i'm using the 28X1 chip
this is the code i used:
main: ‘ make a label called ‘main’
if pin3 = 1 then flash ‘ jump if the input is on
goto main ‘ else loop back around
flash: ‘ make a label called ‘flash’
high 4 ‘ switch output 4 on
pause 2000 ‘ wait 2 seconds
low 4 ‘ switch output 4 off
goto main ‘ jump back to start
Question: When the code specify pin3 does it mean input 3 or leg 3 ?
Is there something wrong with the code?
Once again thank for the support. Thank you !!!!!