Hi,
Bought this board some years back and now am coming back to it. The numbers and even letters of the labels (pins) have been overprinted by the three rows of "gold" plated holes. A 28X has been plugged in. This is what I can see with the power supply, RS232 socket at the top:
Left hand Right hand
A0 B7
| |
A3 B0
C0
|
C7
Below the reset button are the four A's, a bit higher and on the right are the eight B's, and below two jumpers and cap. are the C's starting with C0. Please confirm this positioning. Is the spacing between, e.g., A0 and A1 the usual 1/10" or 2.54mm to put a terminal block there?
So many questions, so little time! Your help is appreciated!
dom
Bought this board some years back and now am coming back to it. The numbers and even letters of the labels (pins) have been overprinted by the three rows of "gold" plated holes. A 28X has been plugged in. This is what I can see with the power supply, RS232 socket at the top:
Left hand Right hand
A0 B7
| |
A3 B0
C0
|
C7
Below the reset button are the four A's, a bit higher and on the right are the eight B's, and below two jumpers and cap. are the C's starting with C0. Please confirm this positioning. Is the spacing between, e.g., A0 and A1 the usual 1/10" or 2.54mm to put a terminal block there?
So many questions, so little time! Your help is appreciated!
dom
Last edited:
