Thank you all for helping. I`m starting to write a state diagram tomorrow and see how it turns out.
Some clarification and coments about some points that was mentioned:
The picaxe is powered by its own 78L05 voltage regulator. I`m using a PTN78060wah smps...
Greetings!
First i want to apologize for my English and I hope you understand me well enough to help me with some coding advice.
I have been around the forum for a couple of years and done some smaller project with PicAxe but nothing really big.
Half a year ago i started building two home...
Greetings!
Im currently working on a serial port sniffer/logger and have run into some things i dont quite understand.
Im using a 28x2 module (AXE200) with a 24LC128 eeprom and 4,7K pullup soldered to the underside of the module.
The main idea is to background recieve one series of data bytes...
This is a small project i made to practice making compact pcb layouts in eagle. It turned out that it`s also good practice at smd soldering.
First I found a circuit-diagram of a descrete dice and found out that this would be even easier to do with a PicAxe. When the design was finished...
Greetings!
I was wandering if i could use a 08M as a NOT gate for inverting serial coms. My plan is to make a serial inverter that can be controlled by a tactile switch to choose if the serial stream shold be inverted or not.
I was thinking in the line of:
Setup for interupt on input 3 to...
Greetings!
Just wandering if I`m on the right track here.
The general idea is to bombard a 08M2 hserin with two bytes containing address for the device and the speed and then let the 08M2 adjust the pwm-frequensy and direction pins(this will be used to drive a currently unknown H-Bridge)
I wrote...
I was thinking..
Is it possible (and if: how) to use a I/O-pin to first detect if a led is connected(via ADC?) and then turn over to a output and controll the led as normal?
Ideas are more than welcome.
While working on a project with the new 18m2 I went to make some coffee leaving my cellphone on the table beside the project(Silent mode). Then i suddenly hear happy birtday start playing and runs back to see whats going on.Then i see that my mother in law is trying to call me. After a quick...
The picture should explain.
Would it be a bad idea to add the red wire to jumpstart the relay?
Must admit i allready done it, but havent had time to check if something is broken yet:rolleyes:.