Recent content by ayounis

  1. A

    RCTIME Equivalent on 20X2

    I needed an RCTIME-like routine to use with a QTR line detector. the standard PICAXE lib does not provide one. as the application in hand did care much about to the micro-sec timing but rather a time span, I had reached the following code. as I am working on a 20X2 device, this is where I have...
  2. A

    hpwm on 20x2

    hello, I have selected 20x2 for its hpwm capability. in a test run I had tried all possible modes, single; half; f_f; f_r, but only the single mode appears to be working correctly. please advice. regards, amr
  3. A

    RCTIME

    gentlemen, any idea how to emulate BS2's RCTIME command?
  4. A

    connection issue

    hi, I am trying to connect to 20x2 from PE but it never worked. I am using normal serial cable connected to a "Pololu 23201a Serial Adapter Fully Assembled" (http://www.pololu.com/catalog/product/126). pin tx of the above mentioned adapter is connected to pin 2 of the 20x2 and rx is connected...
  5. A

    reseting 20x2

    hi, would you please advise how to reset a 20x2 chip. thanks.
  6. A

    Updated Manuals

    Dears, The latest versions of the "Programming Editor" is out with updated BASIC commends but the BASIC manual is still an old one. would you please advise where to find an updated copy of the BASIC manual. regards, Amr
  7. A

    Programming Editor Fails to Program

    Hello, I have just received my PICAXE 28x2 module... my experience so far is a nightmare. I started using the Programming Editor for programming and communicating with the module but that was never been successful but very rarely. before firing any questions I tried the WinAXEpad and for my...
See more
Top