Hi there. im using the Sparkfun serLCD v2.5 on an 18x board.
Sending the most simple of code ;
serout 3, N2400, ("please work")
always outputs the following ;
|| (this is a dash dash in the same character space)
Any ideas?
Im pretty sure its outputting on the correct output as i can add a pause and it does delay the output of the character above. is the serial output limited to only certain outputs?
Any help would be great
Dave
Sending the most simple of code ;
serout 3, N2400, ("please work")
always outputs the following ;
|| (this is a dash dash in the same character space)
Any ideas?
Im pretty sure its outputting on the correct output as i can add a pause and it does delay the output of the character above. is the serial output limited to only certain outputs?
Any help would be great
Dave