fishyghost
New Member
Ok, I know I'm going to have to modify the board.
I have a 5volt supply for the Picaxe
First Question: Do I have to cut any resistors off on the Version 3 board to connect a 12v supply to V2?
Second Question: If I desolder one of the FETS will the Gate have the correct voltage at this point (with no other modification to solder onto the SRF005 Ultrasonic, I'm quite confused with the chi035.pdf and cannot work heads or tails of what is referring to the standard board and what is not).
Third question: Is the board triple layered (if not, where are the tracks for the fets that "miss out" the motor driver, as this is confusing me, I don't plan on using the second IC).
Will this combination work with simple tinkering of the present design? (I'm only adding one ultrasonic to the board).
Thanks in Advance,
Craig
I have a 5volt supply for the Picaxe
First Question: Do I have to cut any resistors off on the Version 3 board to connect a 12v supply to V2?
Second Question: If I desolder one of the FETS will the Gate have the correct voltage at this point (with no other modification to solder onto the SRF005 Ultrasonic, I'm quite confused with the chi035.pdf and cannot work heads or tails of what is referring to the standard board and what is not).
Third question: Is the board triple layered (if not, where are the tracks for the fets that "miss out" the motor driver, as this is confusing me, I don't plan on using the second IC).
Will this combination work with simple tinkering of the present design? (I'm only adding one ultrasonic to the board).
Thanks in Advance,
Craig