Hallo,
After a long time I am starting (again) with the PicAxe chips.
As a starter I have purchased a PICAXE-08 PROTO BOARD KIT.
In the axe021.pdf I read:
2. Insert a PICAXE-08 or 08M micro-controller (purchased separately). If desired
an electrolytic capacitor (e.g. 100uF) may be soldered beside the battery clip
for voltage smoothing on noisy circuits.
Just to be sure, I think the 100uF has to be a 100nF.
Am I right?
Thanks,
Greetings from The Netherlands,
Henk Siewert
After a long time I am starting (again) with the PicAxe chips.
As a starter I have purchased a PICAXE-08 PROTO BOARD KIT.
In the axe021.pdf I read:
2. Insert a PICAXE-08 or 08M micro-controller (purchased separately). If desired
an electrolytic capacitor (e.g. 100uF) may be soldered beside the battery clip
for voltage smoothing on noisy circuits.
Just to be sure, I think the 100uF has to be a 100nF.
Am I right?
Thanks,
Greetings from The Netherlands,
Henk Siewert