I have a temperature data collection program using 18M2 that stores the readings in eeprom. I use the PE6 Terminal Utility to display the readings read from eeprom as they are collected. I have also set up a adatalink port using C.6 and B.7 to send serin C.6, N4800 ("G") and then serout B.7, N4800 the data to DataLink Utility. I must not be using the Utility correctly. When DataLink is selected from the PE6 screen, I do not see any options selections on the screen. I can send data and see it shown in the rectangular box above 'Upload', but I see no choices for graphing. The screen I have seen of a working datalink has " File........Option...." across the top of DataLink screen: I see none of that.
Where in my life have I gone so wrong that even these simple pleasures are denied me?
John
PA Anderson created all of the "data log" to eeprom code I used except for portion attached and other minor changes
Where in my life have I gone so wrong that even these simple pleasures are denied me?
John
PA Anderson created all of the "data log" to eeprom code I used except for portion attached and other minor changes
Code:
DataLink:
high C.3 ; Looking for "G" return to start LED
serin C.6, N4800, ("G")
pause 10
serout B.7, N4800, ("Address",com,"Temp",CR,LF)
low C.3 ; got the "G" so now send data to DataLink Utility
gosub LinkDump
low C.7 ; data sent LED
goto lock
LinkDump:
high C.7 ; sending data LED
Read AddressPtr, address
if address = 0 then noLoggedData
address = address - 1
for n = 0 to address
read address, data0
serout B.7, N4800, (#address,com,#data0,com,CR,LF)
next
serout B.7, N4800, (0) ' added to indicate end of transmission of data (made no difference in out come)
return
Last edited: