twentytwoo
New Member
I've been looking around this forum a lot about various ways of integrating SD cards in their projects, I noticed two popular ways of doing this.
One using the ALFAT SD module by GHI and the other via SparkFuns OpenLog.
My situation is a little easier in that I only require reading data from the SD card, I know a lot of people on this forum have dabbled in FAT file systems and had a lot of trouble.
Essentially all I want to do is load some hex values onto an SD card via computer, insert this SD card into either of the above modules, and then get this data and output it onto one of the PICAXE's ports.
I've done quite a bit of work with PICAXE, but only in the AQA Assembler (PIC 28x1), so I'm here asking about anyone who's had any success with either of these modules.
Thanks.
One using the ALFAT SD module by GHI and the other via SparkFuns OpenLog.
My situation is a little easier in that I only require reading data from the SD card, I know a lot of people on this forum have dabbled in FAT file systems and had a lot of trouble.
Essentially all I want to do is load some hex values onto an SD card via computer, insert this SD card into either of the above modules, and then get this data and output it onto one of the PICAXE's ports.
I've done quite a bit of work with PICAXE, but only in the AQA Assembler (PIC 28x1), so I'm here asking about anyone who's had any success with either of these modules.
Thanks.
Last edited: