I an using the latest m14 chip for my project. I wrote the code, it is perfect. Wired the project on a breadboard..chip works perfectly. Wire the project on a project board ( I am using chip holders with cyclendrical fingers and one with clip type fingers. Both bought on eBay) plug in the chip and the project works perfectly for a day or so then quits. I install the chip back into the breadboard test bed and the chip performs flawlessly. It will not work in the final project board. I have tested the board completely and all components are fine. This has happened on 5 different project boards that I have made. I narrowed it down to the chip holder. Is there a special way to solder the chip holder to the board? Is there a way to assure contact between the chip and the holder? Can I solder a chip directly to the board to prove to myself that it is the holder. I must be doing something wrong