Am i going to have problems when using multiple pots wired into the Analog inputs?
Looking at my sketch below, i've basically wired 4 x 10K pots across the +5volt and ground rails, then feeding the wipers into the Analog inputs.
In this case, the overall pot resistance would only be 2.5K, is this going to be a problem? and is adjusting 1 pot going to actually slightly adjust the other pot values too?
Will the addition of diodes in series with the pots isolate them from affecting eachother?
In the grand scheme, i'd be using 10 x pots or upto 16 pots.