After a protracted time away from this project (moving house) I tried to program an 08M2 with a short, simple program that I've programmed many times before, and suddenly I'm getting an error message at the end of programming, although the chip responds as though the program loaded correctly
The error message is this:
Firmware >= B3 adcconfig not supported by this firmware version.
I am using 6.0.8.6 which is a few steps behind but looking at the updates I don't see anything that would cause this error, whatever it is.
Does anyone have any thoughts?
The error message is this:
Firmware >= B3 adcconfig not supported by this firmware version.
I am using 6.0.8.6 which is a few steps behind but looking at the updates I don't see anything that would cause this error, whatever it is.
Does anyone have any thoughts?