Just curious if anyone has any experience with a 2 x 16, blue, backlit LCD made by TinSharp. Say it has a SPLC780 D1 controller in it. (is it a non standard controller???) I was given a few of these (new old stock) a couple years ago and thought I'd use one yesterday. I can't seem to get it to initialize. Can't even get any gibberish on it let alone a "Hello World".
Tried heaps of different code, but no go.
I'm not the greatest at LCD's but I've had a few projects in the past that used serial and parallel LCD's and never had any issue. Pretty straight forward stuff. I think it's an initialization problem. Anyone familiar with a Tinsharp 2 by 16 LCD, model TC1602A-09T.
28X2
8 bit mode
DB0 - B.0 , DB1 - B.1..... DB7 - B.7
Enable - C.7
R/S - C.6
R/W - Low (connected to 0V)
Thanks
Tried heaps of different code, but no go.
I'm not the greatest at LCD's but I've had a few projects in the past that used serial and parallel LCD's and never had any issue. Pretty straight forward stuff. I think it's an initialization problem. Anyone familiar with a Tinsharp 2 by 16 LCD, model TC1602A-09T.
28X2
8 bit mode
DB0 - B.0 , DB1 - B.1..... DB7 - B.7
Enable - C.7
R/S - C.6
R/W - Low (connected to 0V)
Thanks