I am starting on some Halloween projects and wanted to make a "simulated" rotating tunnel that people would walk through. Basically a tube with chasing lights to simulate the tube was spinning. So I made a simple program with 10 outputs, connected to triacs for the strings of light (40 total). I started out with a "Pause 20" between the high, lows but wanted to add a pot to control the speed. I added ADC but it does not control the speed. When I use this ADC on a single output, the pot works fine. Is it because I am for lack of a better work sharing the ADC "b5" task?
Dave
Dave
Attachments
-
743 bytes Views: 12