During programming the picaxe 20x2 i removed the power supply...The manual say that i should do a hard reset. I do the same thing that the manual sad, but it wasn't work. I always get an error massage :'No hardware found on COM1 Port'
I have two another chip, 8m2, and 18m2, these are work fine, i can program these.
What can i do? Is the 20x2 broke down finally due to my fault?
Thanks for the anserws,and sorry for my English.Best regards!
I have two another chip, 8m2, and 18m2, these are work fine, i can program these.
What can i do? Is the 20x2 broke down finally due to my fault?
Thanks for the anserws,and sorry for my English.Best regards!