Good afternoon,
i introduce myself, my name is Andrea and i’m writing from Italy. I’m a newbie with the Picaxe and I need some information regarding my project.
By a Picaxe 08M2 i have to control a Yaesu FT847 rigs with own serial protocol. Each instruction to send the radio consist of 5 bytes, the pause between each byte must be 200mS, the format of the single byte is:
- start bit - bit0 – bit1 – bit2 – bit3 – bit4 – bit5 – bit6 – bit7 – stop bit – stop bit – Total are 11 bits
As you see this protocol is different from the protocol of Picaxe that is - 8bit data – no parity – stop bit –
My question is: how can I write the right code in order to meet the requirements Yaesu’s protocol ??
I apologize if the topic has already been treated, but have not found anything like.
Thank you for the help.
Andrea P. IZ3KXW.
i introduce myself, my name is Andrea and i’m writing from Italy. I’m a newbie with the Picaxe and I need some information regarding my project.
By a Picaxe 08M2 i have to control a Yaesu FT847 rigs with own serial protocol. Each instruction to send the radio consist of 5 bytes, the pause between each byte must be 200mS, the format of the single byte is:
- start bit - bit0 – bit1 – bit2 – bit3 – bit4 – bit5 – bit6 – bit7 – stop bit – stop bit – Total are 11 bits
As you see this protocol is different from the protocol of Picaxe that is - 8bit data – no parity – stop bit –
My question is: how can I write the right code in order to meet the requirements Yaesu’s protocol ??
I apologize if the topic has already been treated, but have not found anything like.
Thank you for the help.
Andrea P. IZ3KXW.