Hi, Iam a bit new to this but I have a PNS on my home network and I have set it up and it works fine. I have set the router to forward port 80 and I can get remote access without any problems with the net demo board connected.
The problem came when I have tried to download a very simple program to a 28X chip in the axe022 project board. The program just switches an LED on and off on output pin 7.
The download to picaxe always returns a failed message and I can no longer view the web pages and I have to download the webpages again in order to view them. The 3 jumpers are all in the RH position enabling download and power to the board from the PNS.
The netdomo board works fine.
Any ideas?
Iam downloading the picaxe program via the network, FTP, then "programme picaxe". The FTP transfer is fine and returns a sucessful message.
The problem came when I have tried to download a very simple program to a 28X chip in the axe022 project board. The program just switches an LED on and off on output pin 7.
The download to picaxe always returns a failed message and I can no longer view the web pages and I have to download the webpages again in order to view them. The 3 jumpers are all in the RH position enabling download and power to the board from the PNS.
The netdomo board works fine.
Any ideas?
Iam downloading the picaxe program via the network, FTP, then "programme picaxe". The FTP transfer is fine and returns a sucessful message.
Last edited: