Search results

That's right, I changed the program. This is the proper configuration: Further underneath is wrong.

I have tried this on the tutorial: 4. Connect an LED and 330 ohm resistor to the output pin 4 of the PICAXE chip. main: high B.4 pause 1000 low B.4 pause 1000 goto main And it worked! I changed to B.4 again and put the wire in B.4 The ground in 0V The resistor between the B.4 and the...

The microcontroller is situated like this. I tried this to make sure something was happening on the board and the microcontroller would be recognized. I have tried to plug in the AXE027 at the middle socket as well, but it wasn't recognized either. Hereby the picture:

Dear all, When clicking 'Firmware' on the following panel: I get: Who can help me? I have everything attached to the AXE091 board.

I have tried the other ports and the hard reset but I get the same error: I have build a small circuit on the breadboard by connecting a led to the v+ and the v0 The led is burning. Can anyone tell me why the cable doesn't find the hardware? Underneath I have a picture of the configuration...

This might be a clue. I will try this one out. I have the microcontroller inserted on the starterkit and plugged the cable in one of the sockets. I have to figure out what to do next. I hoped the green light on the kit would start blinking right away. Thank you.

Everything is done like you said. I probably have to walk the tutorial through because I still get the following message: I am getting closer though. With everything configurated I have no clue what to do with the starterkit and how to use the breadboard. The green light on the board works...

Dear people, could you help me, starter, with this problem. I have a AXE091 starterkit, my Blockly picaxe editor recognizes my usbcable but when I run the program I get the following error: hardware not found on /dev/tty.usbserial-0000 I plugged in the usb and at the other side the picaxe...