Search results

Hi all I am having trouble with a project I cannot seem to find a solution. I need to sense if a reel has stopped turning via a slotted opto there is a flag on the reel. When the reel stops the flag will be in the sensor and the sensor will be high. However as the flag is always passing through...

Hi I have a program running a machine and all is working well. I am trying to add a counter that will stop the machine after a set amount, at the moment I can only get it to count up to 255 then stop. In the program if i want to count large numbers possibly 5 to 10,000. I use the W as apposed to...

Hi I have enclosed a part of the program I am using to spool tape off one spool to another spool. It is working fine it stops just before the end and then move on to rewind. I would like to change it slightly I would like to stop and reverse at a point I select. At the moment the count is about...

Hi i have two motors with a hall sensor on each with a full reel of tape on one and an empty spool on the other, i need to run the tape of the full one onto the empty one and back again without the tape running off (going to far). My idea is to count both sensor pulse's until they are the same...

Hi I am new to the picaxe. I am using the picaxe-40x2 and the problem I have is trying to count the pulse's from a brushless motor with three hall sensors set at 120 degrees apart, they are connected a/pin d.1, B/pin d.2, and C/pin d.3. I only need to count off one of the sensors the others are...