Recent content by Spirobot

Hi, I am trying to run a 100w dc motor off a picaxe with PWM. I want to use a HFS33 solid state relay (jaycar sy-4086). The data sheet has input terminals 4- and 3+. Do I attach 0v to the 4- terminal and an output pin of a picaxe (pwm) to the 3+ terminal. Output of the HFS33 solid state relay...

Hi, I am trying to run a 100w dc motor off a picaxe with PWM. I want to use a HFS33 solid state relay (jaycar sy-4086). The data sheet has input terminals 4- and 3+. Do I attach 0v to the 4- terminal and an output pin of a picaxe (pwm) to the 3+ terminal. Output of the HFS33 solid state relay...

I have been using a Picaxe 28x1 with a 5v regulated power and using a 4.7k resistor to tie the reset pin high with a push switch to reset the pin (0v). I am about to use a Picaxe 28x2 with a 3.3v regulated supply. Do I tie the reset pin high with a 4.7k resistor or do I have to change the...

Hi, I have read the following information in a Post. "From Picaxe manual 2, page 133 “When using the debug command to output 10 bit numbers, the electrical connection to the computer via the serial download cable may slightly affect the ADC values. In this case it is recommended that the...