Recent content by paperchaser

I have just been let down on a project. I have therefore decided to try and do it myself. However - I need help with the programming and design. It is a small commercial project so some of the software has to be kept confidential. When it is finished I have also decided to make available to...

This is a bit embarrassing. I never done anything like this before and don't quite know where to begin. I checked the manuals and forum, nothing seemed to jump out and solve the problem. I am expanding my gas project. So here goes. I read a serial input data into a 18x. The output is to a...

I have a little project that requires that I make a reasonable quantities of a gadet. I don't want to buy all the picaxe chips that are required at once as this is a bit expensive. So I would like to do them in batches, Then fit into my gadget. My questions are - Is it possible to copy a Picaxe...

Following on from my previous post on my Data Logger project. I thought I would post this before re-inventing the wheel. I have searched the obvious places for guidance but there seems very little on this out there. I have a 2x16 EA DOG-M display bashed into my breadboard for hooking up since...

This may sound silly, but I have looked without much a solution jumping off the manual and hitting me. So here goes. No values - Page 8 section 3 . Output Interfacing. I want to power the LCD I have (5v @ 1.0mA to 1.5mA) direct from a picaxe 40x2. (5V) I would also like to power the LED back...

Hello and thanks in advance for the help. I seem to be having a few problems with inputs. I'm sure I must be doing something daft. I have read the interfacing section of the manual and I guess I either don't understand it or I stupid, or worse it could be both. Equipment. 1 x a 28 -pin...

Hello, New here. I have watched for ages, slowly learning how to do things. However I am now stuck and need some help I manage most times to find an answer somewhere off the forum but I have hit a bit of a dead end. (or one of those older moments) I am upgrading one of my projects that runs...