Recent content by Nicol60

Hi Hemi thanks for your info, I will order a board and give it try. jim

Hi Sorry for the delay in my reply, I have attached a picture of the project. This shows the head mounted on a PTZ from a CCTV camera. One motor gives vertical movement and the other gives horizon. I could fit end stops if required but as yet I have no drivers for the motors. I tried an Arduino...

Hi The PTZ unit supports the two stepper motors one in the horizontal and the other vertical. So when the vertical unit is powered it gives an Up Down movement and the other provides for Left to right. Others items are perhaps two servos one for the jaw and the other for the eyes but there is...

Hi I have been away from Picaxe for some time so give me some flexibility with this request in case the answer is in plain sight. I would like to control two stepper motors with one double joy stick. That is a stick that say Right and Left would control one motor and Up and Down the other...

Hi I am trying to build a sports timer, I have the 7 segment display working but what I need is a accurate clock pulse. I have tried the pulsout command with the line Pulsout send a 10us out via pin 5 wait 1.0 sec then loop. Sorry about the description but I am using the Logicator...

Hi Just back to picaxe after some time off. I was looking for a low battery warning. I have a door alarm project which would run off say 9v with the suitable reg circuit to supply the picaxe. I think I need 9v as a base in order to get a loud output. However I would like to know when the 9v...