#PICAXE 28X2
#no_table
#rem
#
# This program reads the raw gyro, magnetometer and accelerometer values from a
# MinIMU-9 V2 MinIMU-9 v2 Gyro, Accelerometer, and Compass (L3GD20 and LSM303DLHC Carrier)
# http://www.pololu.com/catalog/product/1268
#
# jaybeetoo May 2013
#
#endrem
;
; MinIMU-9 V2...
This module enables you to time events in milliseconds using Timer1. It is the module written by Jeremy Leach but I've amended it to work on the 28X2.
#PICAXE 28X2
#rem
#
#######################################################
# TIMER1 test code #...
I know this is probably a very simple question to most of you on this forum but I'm new to electronics and we all have to start somewhere!
I want to use a Picaxe pin (e.g C.5 on a 28X2) to switch a GPS module on and off. The instructions for the GPS module says there is an enable pin...
I am trying to read the subject IMU. The datasheets are at http://www.pololu.com/catalog/product/1268/resources.
I've started by just trying to read the gyro. I've read the WHO_AM_I register and I get $D4 which is correct. However, when I read the X, Y and Z registers, their values do not...
I recently bought an Ultimate GPS Breakout http://www.adafruit.com/products/746 with the MTK3339 chipset.
I couldn't find any documentation for use with the PICAXE so I've been playing around with it. The factory default setting is 9600 baud. The only PICAXE pins I could get to work with the...
I am seeing some very strange behaviour with nested Do Loops in the Simulator (PICAXE Programming Editor V5.5.5).
The following simple program illustrates the problem:
#PICAXE 08M2
let b0 = 0
let b1 = 0
do while b0 < 2
inc b0
let b1 = 0
do while b1 < 2
inc b1
loop
loop
end...
I am having problems with blinking characters on the AXE134 Serial 20x4 OLED.
I write characters to the first line of the display. I make one of them blink. When I then write characters to the second line, the blinking character in the first line stops blinking. If I then write something to...
I am using the PICAXE development board (AXE091). I have installed the DS1307 RTC and put a battery across pins 3 and 4.
I am trying to set the date/time and then read it.
I can get it to work with an 08M2 with pin 5 (C.2) connected to the hi2c sda header and pin 6 (C.1) connected to the hi2c...