Recent content by darosu

Hi Guys. Just a quick question. I am looking to put together a serial servo controller board. Ideally it would control 8 servos and multiple modules can be run from the same serial commnication comming from my master PICAXE. Each module would have jumpers to select the starting address of the...

Hi guys. Run into a little trobule again, wonder if you might have an idea... The short of it: Recieving hardware serial on 40X2 and althoguh HSERPTR increments correctly the data in scratchpad is always '0' The long version: Have built an RFID Concentrator module (From MERG - Model...

Hi all again. I am making good progress and have developed a 20X2 that can read Hserial data in, process it and send it out of a slower software serial port to my graphic LCD module. In the end this will include all of my code for icons, menus, i need for my application, without tying up my...

Hi guys... ...sorry to bother you all with another annoying 'i'm too stupid to figure it out' question...but here it is anyway: I am trying to set up a 'graphics driver' chip from an 20X2. Effectively it will recieve serial data at 9600 then either send it out directly at 2400 to my Graphical...

Dear all knowledgable people out there.. I cannont interface with my Serial GLCD display if i clock my 40X2 picaxe to 32mhz (8Mhz external crystal) as there are no baudrate options for 32, only 4,8 or 16. I am looking for 2400 baud, and the lowest i can trick it to is 4800 by telling it I have...

Hi all, I wondered if you can help me?? I have just dipped my toe into the world of PICAXE but am strugling a bit. I have set up a 40x2 on a breadboard with an 8Mhz resonator (so running at 32Mhz I believe). It is connected to the LED042 GLCD module. I have managed to control the GLCD via...