View Profile: stan74 - PICAXE Forum

Tab Content: All; stan74; Friends; Photos

Older Activity
10-08-2017, 12:25

stan74 replied to a thread Sharp IR Sensor Algorithms in User Projects - Robots

1st Sharp I ordered never arrived so bought 1 from UK supplier. They're over £12 each. I can't remember if it's acquisition time is in the data sheet...

see more

7 replies | 769 view(s)
09-08-2017, 19:08

stan74 replied to a thread erco-laser range finder in User Projects - Robots

This looks easier to translate. The device needs 5 to 3.3 logic level converter. https://github.com/kriswiner/VL53L0X/blob/master/VL53L0X_t3.ino ...

see more

11 replies | 499 view(s)
09-08-2017, 16:48

stan74 replied to a thread Sharp IR Sensor Algorithms in User Projects - Robots

I used a2dval=readad10(a2d) a2dval=6050/a2dval if a2dval>=2 then a2dval=a2dval-2 end if if a2dval<10 then a2dval=10 end if if a2dval>80...

see more

7 replies | 769 view(s)
08-08-2017, 19:20

stan74 replied to a thread 18m2 Trying to make a Axle counter help? in Active PICAXE Forum

Hmm. well a generic count from any input not 0 or off is just wait for it to go on or 1.. that's your init or start then check it's gone off...else...

see more

10 replies | 297 view(s)
08-08-2017, 17:11

stan74 replied to a thread 5V voltage regulator capacitor values in Active PICAXE Forum

It will give 5V at 1A at 12V but will need a heat sink. Powering a pic from the reg at 12V will not need a heat sink as the pic only takes mA's even...

see more

33 replies | 1016 view(s)
08-08-2017, 16:57

stan74 replied to a thread 18m2 Trying to make a Axle counter help? in Active PICAXE Forum

What I'm after is the Picaxe 18M2 to count a number of input pulses from 0 which will then set a output to high when count number is higher than 0....

see more

10 replies | 297 view(s)
08-08-2017, 00:35

stan74 replied to a thread 5V voltage regulator capacitor values in Active PICAXE Forum

get a low drop out reg...

see more

33 replies | 1016 view(s)
26-07-2017, 17:51

stan74 replied to a thread Understanding pin descriptions in the manuals (in particular PWM pins) in Active PICAXE Forum

It's confused me. On 28x2 4 pins c.x and b.x work for pwm but servo is an interrupt and uses certain timers and pwm is software it seems not hardware...

see more

6 replies | 262 view(s)

No More Results

stan74
Senior Member

Mini Statistics

Recent Visitors

Basic Information

About stan74

Statistics

Total Posts

General Information

stan74 Senior Member

Mini Statistics

Recent Visitors

Basic Information

About stan74

Statistics

Total Posts

General Information

stan74
Senior Member