Originally Posted by paco556
I read hsersetup can set non common value to communicate via rs232 in this case device is at 56000bauds how can i make the command line with the number it needs to set this baud rate?
I read that at clock on picaxe device running 32mhz needs a number I made the math and gives me a 141 number how can I use it and how the command line looks like?
hsersetup b141_8, %11
But compiler is saying there is a syntax error.
I want to ecco the 56000 baud from the
Prompted by edmund's miniature line follower ( http://www.picaxeforum.co.uk/showthr...r-final-strech) , I've started one of my own.
Not being in possession of the requisite tools ( i.e skills and patience ) for building a miniature vehicle, I bought one ready built.
With the body off it looks like this. ( USB for size comparison )
Originally Posted by JAM1959
I will only log suspension movement up and down,2 front pots and 1 rear as rear suspension runs a monoshock system.I will only log for one lap to start off with.Then I can come home pull suspension down to that point and see what happens with wheel aligment angles...I wud also like a 360 deg pot on steering shaft to measure steering angle.Hope that makes senses.Take baby steps......first
Ubuntu 14.04 or 16.04 AMD64
//setup install :
// lib gtk2 32 bits
terminal : root
: password . . . .
apt-get install libgtk2.0-0:i386 libcairo2:i386 libpango1.0-0:i386 libgdk-pixbuf2.0-0:i386 libstdc++6:i386
// Cable Axe027
write file named without ext (gedit)
Originally Posted by 3142ron
They supplied all the info for Project AXE002 18M2 STARTER PACK, Board Layout and Schematic Diagram.... In the manual it says diagram to follow.....