I purchased a AXE020 with PICAXE-28X1 microcontroller.
When I powered everything up, connected it, and run code, I get the same "Software i in wrong mode" or "Hardware Not Connected!" error message.
I make sure:
- The chip itself is getting power
- The cable is fully inserted
- The correct serial (COM) port is selected in the software.
Anyone know what might be the problem?
Thank you
When I powered everything up, connected it, and run code, I get the same "Software i in wrong mode" or "Hardware Not Connected!" error message.
I make sure:
- The chip itself is getting power
- The cable is fully inserted
- The correct serial (COM) port is selected in the software.
Anyone know what might be the problem?
Thank you