problem with NET006/PNS

reniera

New Member
Hello,

The PNS seems to work fine but I can't get the stuffs on the NET006 board work as expected. The temp. sensor reports a constant temp of -0,06°, when switching on the output LED, it flashes at regular intervals, the PWM LED also flashes, the LDR reports incorrect figures, the swich on pin 3 doesn't work (although the PNS mode switch on pin 7 works fine), etc...

I'm a bit annoyed that the PNS KIT that I purchased had obviously been used or repaired before ... So I wonder if it's a problem with the PNS.

Thanks in advance.
 
Last edited:

Technical

Technical Support
Staff member
We only ever sell new boards. There is a small SM resistor added on the bottom of the PNS, but that is a factory fix present on every board.

It sounds to us like the cable linking the NET006 to the PNS is faulty/reversed? Or did you solder the socket on the NET006 the wrong way around?
 

reniera

New Member
No, the socket is in the right position (checked with the picture of the NET001).
I just didn't solder the VR1 because it was missing in the package.
 

Attachments

Last edited:
Top